The mainly process for the project are involved in raw material feeding-

crushing - pulverizing - sieving - drying - pelletizing - cooling - packing

1.) Crushing Process:

When the thickness of raw wood material is >10mm, and >50 x 50mm(L x W),

we need use the wood chipper to crush them into small pieces, then pulverize the

small pieces into wood powder with diameter less 3mm by Hammer Mill (Crusher).

2.) Drying Process:

The best moisture content for pelletizing is about 13-15%. Our Rotary Dryer is made up

hot blast furnace and Main Rotary Dryer, which can realize to reduce the moisture from

60% to 10%. Our furnace is fueled by coal or sawdust which can save electricity consumption largely.

3.) Pelletizing Process:

MZLH Wood Pellet Mill is the most important equipment, which have the following features:

A.) The lubrication system for wood pellet mill adopts the tracing and inspecting system controlled by the microcomputer. When the temperature of the bearing is over the normal temperature, the microcomputer will start the Auto-Lubrication System to lubricate the bearings, which complete solved the trouble of lubricating roller depending on the operation experience. The Lubrication System is made up of the tracing and inspecting system controlled by the microcomputer, auto-lubricating system on time and compelled lubricating system by hand.

B. )Driving Gear adopts the high precision gear transmission structure. The wear bearing is SKF from Sweden. The ring die adopts the hoop fastening method, which is increasing the speed of discharge comparing with the past bolt fastening method. As a result, the capacity is 10-15% higher than the belt transmission structure. 

C.) As per the ring die and roller of the wood pellet mill, we have the fine machining with the alloyed steel. And our heating treatment is also different from the other domestic manufacturer, our carburizing treatment make the depth of hard facing to 2mm, which improve the anti-abrasion of the ring die and roller more than 10 times, it can save the production cost heavily.

4. Cooling Process:

After the pelletizing process, the temperature of the wood pellet is about 60-80 degree, and the moisture content of the wood pellet is about 15%, so we need use Cooler to reduce about 3-4% moisture, by this way the wood pellet is easy to store.

But considering the feedback from some foreign clients, the local climate is very humidity; they hope to cool the wood pellet with moisture 7-8%. In order to satisfy the different need from different clients, we develop one kind of new Stabilizer Combined Cooler.

5. Packing Process:

After cooling, the wood pellet will not directly enter into the fuel process, avoiding the wood pellet affected with damp. The packing process is necessary. In this process, we assemble our domestic best Semi-Auto Packing Machine to you